POLYMER LOWER RECEIVER
Jig Set for POLYMER LOWER RECEIVER
We are phasing this product out right now. We have very limited inventory.
Jig Assembly is for the Polymer 80% Lower:
2 Side Plates
1 Top Plate
One time use for only our parts.
(verified owner) – May 27, 2018
The written instructions wasn’t there could you post them on line other than that this looks like a well made receiver
(verified owner) – May 30, 2018
FCP 1.49″ (NO FURTHER) the most common mistake is drilling through the bottom.
Your email address will not be published. Required fields are marked *
Your review *